The Razor Sharp Edgemaking System consists of two compressed paper wheels that will fit on any buffer or bench grinder. One wheel is coated with 180 grit Silicon Carbide and is used to develop a burr or wire-edge along the cutting edge. The included Conditioning Wax (a special formula of fats, oils and waxes) is applied to the grit wheel to lubricate and control heat. The second wheel is slotted and, with the help of the included jeweler's rouge, is used to remove burrs and polish the cutting edge. A grit wheel will sharpen a couple hundred knives before it needs recoating. An additional 3oz container of Silicon Carbide is provided with the kit, enough to recoat the grit wheel 15 to 20 times.
Complete instructions are included in each kit.
Wheels are available in 8" or 10" diameters. If you're using a 6" bench grinder you want the 8" Deluxe kit. The reason for this is that in order to sharpen a knife properly, you must have enough clearance between the face of the wheel and the face of the motor housing to accommodate the handle and your fingers. The 10" Magnum kit comes in either 1" or 1 1/4" thicknesses. We recommend using this kit on an 8" machine.
Deluxe Kits:
| 10" Magnums (1 in)
|
10" Magnums (1 & 1/4 in) |
|
8" Deluxe (The most popular) |
Deluxe Grit Pack(Also sold individually)
|
Individual Shapers (for woodworking and leather working tools)
8" Shapers - 1/4" Thick, 8" Diameter, 1/2" arbor hole
6" Shapers - 1/4" Thick, 6" Diameter, 1/2" arbor hole
4" Shapers - 1/4" Thick, 4" Diameter, 1/2" arbor hole
3" Shapers - 1/4" Thick, 3" Diameter, 1/2" arbor hole
Except for "Shapers," we typically manufacture wheels with an arbor hole of 5/8 inch with a 1/2 inch removable bushing so that it can be used on either sized motor. We can put any size arbor hole to meet your specific needs from 1/2 inch to 3/4 inch.
***This system is unconditionally guaranteed by the makers. If you find any defect in manufacturing or are not satisfied with the product we will replace your product or refund your money, including shipping.***
For more information - This email address is being protected from spambots. You need JavaScript enabled to view it.
For answers to technical questions or problems - This email address is being protected from spambots. You need JavaScript enabled to view it.
